1、平口机的冷切刀切不断怎么办

1. What about the cold cutting of the flat shear machine?

当平口机的冷切刀总是切不断时，要检查切刀是否锋利，是否需要重新磨好；检查上下刀的平衡度是否合适，刀滑块使用久了，磨损有间隙，会导致刀不平衡。

Cold knife when the flat machine is always cut constantly, to check whether the sharp knife, you need to re grind; check the knife of the balance is appropriate, the knife block is used for a long time, wear a gap will lead to unbalanced knife.

2、平口机切三条或多条，袋子尺寸长短不一怎么办

2, flat machine cut three or more, how do the size of bag length

在那一条薄的膜后胶辊上垫上一层，就可以与其他的材料均匀。

On that thin film, the top roller is covered with a layer that can be uniform with other materials.

3、平口机的弹簧断了，是什么原因引起的

3, the flat spring of the machine is broken, what causes it?

自粘条没有贴到位，翘起来卷进弹簧，弹簧就会断，在操作中一定要把自粘条贴好。还有一种原因，料不整齐或一坨塞进胶辊，导致弹簧不顺断掉。

The self-adhesive bar does not stick in place and is bent out of the spring. The spring will break and the tape must be adhered to during the operation. Another reason is that the material is not neat or a lump is stuffed into the rubber roller, which causes the spring to break.

4、骨袋制袋机封边两边差异大怎么办

4, bone bag making machine sealing edge on both sides of the big difference, how to do?

需将铝压辊调试好，调到封边两边都压得到，就会避免出现这种情况。

It is necessary to adjust the aluminum roller to the edge and press both sides. This will be avoided.

5、边封机切自粘条经常粘到输送带是什么原因

5, the side sealing machine, cutting tape often stick to the conveyor belt, what are the reasons?

自粘条错位，粘到了输送带，需要将后面的纠边机的自粘位调试好，把纠边电眼一定要放在自粘位纠边，防止跑位。

Self-adhesive strip dislocation, and sticks to the conveyor belt, to the back of the edge correction machine a self-adhesive debugging, the edge correction must be placed in a self-adhesive electric eye edge correction, to prevent movement.