| 冷切制袋机焊刀调整方法 |
| 添加时间：2019/5/25 16:43:41 浏览次数： |
| 冷切制袋机焊刀调整方法: Adjustment method of welding knife for cold-cutting bag machine: 在支承座上垫上一张薄纸,用手转动机体箱内的大手轮,使焊刀处于下死点,松开螺帽,调节螺母(注:拉杆调节螺母出厂前基本调好),用手拉薄纸两端的压紧程度,直至大约均等.调毕后,要锁紧螺母,以防松动. Pad a sheet of thin paper on the support seat, rotate the big handwheel in the body box by hand, make tangshan.71ix.cnqinhuangdao.71ix.cnzhangjiakou.71ix.cncangzhou.71ix.cnmiehuo.37ix.com.cnrunhuayo u.89ix.comthe welding knife at the bottom dead point, loosen the nut, adjust the nut (note: adjust the nut before leaving the factory), and pull the tightness of both ends of the thin paper by hand until about equal. After adjustment, lock the nut to prevent loosening. |
| 上一页 物料被自动计量后充填到制成的袋内 |
| 下一页 一次性手套制袋机简介 |
Copyright © 技术支持：遨游网络